1/19/2024 0 Comments Route reflector client![]() ![]() In the BGP routing table, you can see that SwitchD has learned from SwitchB the route advertised from SwitchA, and see the Originator_ID and Cluster_List attributes of the route. ![]() Paths: 1 available, 0 best, 0 select, 0 best-external, 0 add-pathīGP routing table entry information of 172.16.1.0/24:ĪS-path Nil, origin igp, MED 0, localpref 100, pref-val 0, internal, pre 255 bgp 65010 router-id 192.168.3.3 group in_rr internal peer 10.1.7.2 group in_rr peer 10.1.8.2 group in_rr peer 10.1.9.2 group in_rr ipv4-family unicast peer in_rr reflect-client reflector cluster-id 2 commit quit 0 subnet, connected wirelessly via bridged client to the 3G WiFi router, to get internet access. Each route reflector would be configured with other route reflectors as nonclient peers (thus, all route reflectors are fully meshed). In a simple configuration, the backbone could be divided into many clusters. Care should be taken to make sure that none of the BGP path attributes defined above can be modified through configuration when exchanging internal routing. bgp 65010 router-id 192.168.2.2 group in_rr internal peer 10.1.4.2 group in_rr peer 10.1.5.2 group in_rr ipv4-family unicast peer in_rr reflect-client undo reflect between-clients reflector cluster-id 1 commit quit This goes under the reflector section and looks like this. A route reflector can be configured to have other route reflectors in a client group or nonclient group. The neighbor (client) at IPv6 address 2001:DB8:1::1 is configured to have the cluster ID of 0.0.0.6: router bgp 6500 neighbor 2001:DB8:1::1 cluster-id 0.0.0. Configure a route reflector on SwitchB and SwitchC. The following example is configured on a route reflector.The configurations of SwitchA, SwitchB, SwitchC, SwitchD, SwitchE, SwitchG, and SwitchH are similar to the configuration of SwitchF, and are not provided here. Configure IBGP connections between clients, non-clients, and route reflectors.Configure VLANIF interfaces and assign IP addresses to the VLANIF interfaces.The configurations of SwitchB, SwitchC, SwitchD, SwitchE, SwitchF, SwitchG, and SwitchH are similar to the configuration of SwitchA, and are not provided here. Configure the VLAN to which each interface belongs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |